- Texas instruments TCA9534A
- 5-V Tolerant I/O Ports
- Three Hardware Address Pins Allow up to Eight Devices on the I2C bus
- Pin-Change HW Interrupt
-
- On Semiconductor CAT25512
- 128-byte Page Write Buffer
- Additional Identification Page with Permanent Write Protection
- Self-timed Write Cycle
- Hardware and Software Protection
- Block Write Protection
- Protect ¼, ½, or Full EEPROM Array
- Low Power CMOS Technology
- 4,000,000 Program/Erase Cycles
- 200 Year Data Retention
-
- Texas Instruments OPT3002
- Wide Optical Spectrum: 300 nm to 1000 nm
- Automatic Full-Scale Setting Feature Simplifies Software and Configuration
- Measurement Levels: 1.2 nW/cm2 to 10 mW/cm2
- 23-Bit Effective Dynamic Range with Automatic Gain Ranging
- 12 Binary-Weighted, Full-Scale Range Settings: <0.2% (typ) Matching Between Ranges
-
- AVIA HX711
- 2 Input Channels
- Low Noise PGA
- Selectable Gain of 32, 64, and 128
- 80 Samples Per Second
-
- Displays the Status of Each Data and Power Connection
- Signals Pass Through Visualizer with No Losses
- Great for Troubleshooting
-
- mircoSD Card
- Connects to SPI Bus
- Utilizes Native SPI SD Libraries
- E.g. Arduino SD Library
-
- Adapts Trēo to Raspberry Pi Boards
- 8 Trēo™ Connectors
- 4 I2C
- 3 SPI
- 3 GPIO
- 1 UART
- 1 SDIO
- RoHS Compliant
-
- Adapts Trēo to All Arduino Uno Style Boards
- Arduino Boards
- STM32 Nucleo Boards
- Compatible with 5V or 3.3V Boards
- 9 Trēo™ Connectors
- 6 I2C
- 3 SPI
- 3 GPIO
- 1 UART
- RoHS Compliant
- Adapts Trēo to All Arduino Uno Style Boards
-
- Creates Two I2C Connections From One
- Creates Two GPIO Plugs with GPIO0 From One with GPIO0 & GPIO1
-
- 420 Tie-Point Bread Board Layout
- 2 Trēo™ Connectors
- Pull-up Resistors Pre-installed
- RoHS Compliant
- Add custom circuitry to the Trēo™ system