- Connects Trēo™ Devices
- Length: 30cm
-
- Holtek HT16k33
- 4 Digit Numerical Display (Red)
- 16-Step Dimming
-
- Allegro ACS711
- 11mA Precision
- High-Sensitivity Sensing Up to 15.5A
- 100kHz Bandwidth (Response <550ns)
- 6mΩ Resistance Results in Low Losses
-
- On Semiconductor CAT25512
- 128-byte Page Write Buffer
- Additional Identification Page with Permanent Write Protection
- Self-timed Write Cycle
- Hardware and Software Protection
- Block Write Protection
- Protect ¼, ½, or Full EEPROM Array
- Low Power CMOS Technology
- 4,000,000 Program/Erase Cycles
- 200 Year Data Retention
-
- Allegro ACS70331
- 5mA Precision
- High-Sensitivity Sensing Up to 5A (AC or DC)
- 1MHz Bandwidth (Response <550ns)
- 1mΩ Resistance Results in Low Losses
-
- Adapts Trēo to Raspberry Pi Boards
- 8 Trēo™ Connectors
- 4 I2C
- 3 SPI
- 3 GPIO
- 1 UART
- 1 SDIO
- RoHS Compliant
-
- Texas instruments TCA9534A
- 5-V Tolerant I/O Ports
- Three Hardware Address Pins Allow up to Eight Devices on the I2C bus
- Pin-Change HW Interrupt
-
The Raspberry Pi 4 2GB offers a 1.5GHz 64-bit quad-core Cortex-A72 (ARM v8) processor, dual-band wireless LAN, Bluetooth 5.0/BLE, Gigabit Ethernet, and Power-over-Ethernet support (with separate PoE HAT) -
The Raspberry Pi 3 B+ offers a 1.4GHz 64-bit quad-core processor, dual-band wireless LAN, Bluetooth 4.2/BLE, faster Ethernet, and Power-over-Ethernet support (with separate PoE HAT) -
The Raspberry Pi 4 4GB offers a 1.5GHz 64-bit quad-core Cortex-A72 (ARM v8) processor, dual-band wireless LAN, Bluetooth 5.0/BLE, Gigabit Ethernet, and Power-over-Ethernet support (with separate PoE HAT)
-
- Arduino Uno Compatible
- Connects To Breadboard
- Injects 5V or 3.3V Into Power Rails
- 1800mAh LiPo Battery
- Secondary Wiring Header
- Breadboard Included
-
STM32 Nucleo-64 development board with STM32F411RE MCU is compatible with the Trēo system, supports Arduino, and ST morpho connectivity.
